X10 mini pro will not sync via wifi connection (USB works)

[HondaCBX]

I would like to sync my Outlook calendar and contact via wifi connection.
Downloaded MPE client on market and started sync via USB. Then tried to sync via wifi. The computer and the phone are connected to the same network (router via wifi). Have tried to disable the Windows firewall and also downloaded a MPE client beta 1.0.7 beta 13 that I found when searching for this problem (did not make any difference). Any suggestions?

Run Android 2.1 on my SE X10 mini pro. The search time for wifi connection during sync is very short.

The USB sync works very good, but of coarse needs a cable and wifi would be simpler i think.

[StefanGaller]

it works fine on my x10 mini (android 2.1).

What does the client in your x10 mini pro say? Are you connected to wifi (not system info, I mean the info in the client)?

[HondaCBX]

The client says connected to wifi and shows the corrcect ip adress that my router also shows.

[StefanGaller]

did you try to enable "wifi" instead of "autodetect" in "connection options"? Maybe (not very hopeful though...) this might help.

If this doesnt help please post debug log!

[HondaCBX]

Have tried that and it does not help.

Logdatei MyPhoneExplorer
************************
Programmversion: 1.8.0
Datum: 2010-12-16

17:41:32.92 Setting Port: 999
17:41:32.92 Setting Baud: 115200
17:41:32.92 Avaiable Ports: COM1=\Device\Serial0; COM3=Winachsf0; COM6=\Device\porte6; COM7=\Device\porte7; COM10=\Device\porte10; COM11=\Device\porte11; COM12=\Device\porte12; COM13=\Device\porte13; COM14=\Device\porte14; COM20=\Device\porte20; COM21=\Device\porte21; COM22=\Device\porte22;
17:41:32.92 Main Load frmSplash
17:41:32.93 Load frmSplash...
17:41:33.29 Hauptfenster wird geladen
17:41:33.45 Sidebar fertig geladen
17:41:33.50 UC SMS wird geladen
17:41:33.54 UC Phonebook wird geladen
17:41:33.59 UC Phonebook fertig geladen
17:41:33.59 UC Calls wird geladen
17:41:33.60 UC Organizer wird geladen
17:41:33.70 Organizer initiated
17:41:33.70 Startpage=2
17:41:33.71 DoItemUpdate
17:41:33.75 DoItemUpdate fertig
17:41:33.75 UC Filebrowser wird geladen
17:41:33.79 UC Filebrowser fertig geladen
17:41:33.79 UC AppBrowser wird geladen
17:41:33.81 UC Notes wird geladen
17:41:33.82 UC Calls wird geladen
17:41:33.85 Setting Lastuser: Sony Ericsson U20i [xxxxxx]
17:41:33.87 Lade Userdatenbank: Sony Ericsson U20i [xxxxxx]
17:41:34.00 LoadDatafile: Phonebook.dat(79948 Bytes)
17:41:34.15 Kontakte geladen
17:41:34.15 LoadDatafile: Calls.dat(28 Bytes)
17:41:34.15 Anrufe geladen
17:41:34.17 LoadDatafile: Organizer.dat(134668 Bytes)
17:41:34.42 DoItemUpdate
17:41:34.46 DoItemUpdate fertig
17:41:34.50 DoItemUpdate
17:41:34.54 DoItemUpdate fertig
17:41:34.60 Organizer geladen
17:41:34.60 Notizen geladen
17:41:34.60 Load SMS Data...
17:41:34.60 LoadDatafile: SMS.dat(1766 Bytes)
17:41:34.60 SMS - Datenbank wird geladen...
17:41:34.62 SMS Laden - Readfile: 0 Split: 16 Parse: 0 HandleMultiSMS: 0 Nachrichten: 16
17:41:34.63 RefreshList (Archive): Addrows=0 Sort=0 MenuUpdate=0 Redraw=0
17:41:34.65 SMS Data Loaded...
17:41:34.65 SMS geladen
17:41:34.76 Hauptfenster fertig geladen
17:41:35.34 Downloader: RC=6 BytesMax=5 URL=http://www.fjsoft.at/myphoneexplorer/version.txt
17:41:54.04 WM_POWERBROADCAST 10
17:41:57.21 Refresh ComDescriptions...
17:41:57.26 PORT: COM1 Enumerator=ACPI Displayed=Communications Port InstanceID=ACPI\PNP0501\4&2F94427B&0
17:41:57.28 PORT: COM10 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\10
17:41:57.28 PORT: COM11 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\11
17:41:57.28 PORT: COM12 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\12
17:41:57.28 PORT: COM13 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\13
17:41:57.28 PORT: COM14 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\14
17:41:57.28 PORT: COM20 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\20
17:41:57.28 PORT: COM21 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\21
17:41:57.28 PORT: COM22 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\22
17:41:57.28 PORT: COM6 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\6
17:41:57.28 PORT: COM7 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\7
17:41:57.32 MODEM: COM3 Enumerator=HDAUDIO LocationInfo=Internal High Definition Audio Bus FriendlyName=Conexant HDA D330 MDC V.92 Modem InstanceID=HDAUDIO\FUNC_02&VEN_14F1&DEV_2C06&SUBSYS_14F1000F&REV_1000\4&8F2C18F&0&0102
17:41:57.87 StickyNotesPath=C:\WINDOWS\Sysnative\StikyNot.exe FileExists=False
17:42:07.17 OK pressed in settingswindow
17:42:07.23 Set first swap of settings
17:42:07.23 Apply new holidays
17:42:07.25 DoItemUpdate
17:42:07.35 DoItemUpdate fertig
17:42:07.37 Holidays applied
17:42:07.37 Second swap of settings set
17:42:07.37 Everything is done
17:42:09.40 WM_POWERBROADCAST 10
17:42:12.54 Broadcaster started
17:42:12.54 Sending broadcast
17:42:13.04 Sending broadcast
17:42:13.54 Sending broadcast
17:42:14.54 bOpened=False
17:42:14.54 IP-adressen kunde inte erhållas
17:42:14.54 Refresh ComDescriptions...
17:42:14.65 PORT: COM1 Enumerator=ACPI Displayed=Communications Port InstanceID=ACPI\PNP0501\4&2F94427B&0
17:42:14.67 PORT: COM10 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\10
17:42:14.67 PORT: COM11 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\11
17:42:14.67 PORT: COM12 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\12
17:42:14.67 PORT: COM13 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\13
17:42:14.67 PORT: COM14 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\14
17:42:14.67 PORT: COM20 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\20
17:42:14.68 PORT: COM21 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\21
17:42:14.68 PORT: COM22 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\22
17:42:14.68 PORT: COM6 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\6
17:42:14.68 PORT: COM7 Enumerator=BLUETOOTH Displayed=BT Port InstanceID=BLUETOOTH\0004&0002\7
17:42:14.76 MODEM: COM3 Enumerator=HDAUDIO LocationInfo=Internal High Definition Audio Bus FriendlyName=Conexant HDA D330 MDC V.92 Modem InstanceID=HDAUDIO\FUNC_02&VEN_14F1&DEV_2C06&SUBSYS_14F1000F&REV_1000\4&8F2C18F&0&0102
17:42:14.78 ErrMsg: Kan inte ansluta till telefonen:
IP-adressen kunde inte erhållas

[Parrotsquawk]

did you try to enable "wifi" instead of "autodetect" in "connection options"? Maybe (not very hopeful though...) this might help.

If this doesnt help please post debug log!

I got my wifi to work by switching it from autodetect to wifi.

I sync'd once via wifi, reset it to autodetect, closed and reopened it and now it works with wifi under autodetect.

Note: you have to stop then restart the phone explorer on your phone after you change your settings on the desktop.

[HondaCBX]

did you try to enable "wifi" instead of "autodetect" in "connection options"? Maybe (not very hopeful though...) this might help.

If this doesnt help please post debug log!

I got my wifi to work by switching it from autodetect to wifi.

I sync'd once via wifi, reset it to autodetect, closed and reopened it and now it works with wifi under autodetect.

Note: you have to stop then restart the phone explorer on your phone after you change your settings on the desktop.

Have tried to put it to wifi and the client says connected to a certain ip, but not found by the MPE when trying to sync.

Any more suggestions?

[FJ]

- ensure that no firewall blocks MyPhoneExplorer
- ensure that the Router allows to find local connected devices (UPnP or similar)
- start the client on phone before you want to connect

[HondaCBX]

- ensure that no firewall blocks MyPhoneExplorer
- ensure that the Router allows to find local connected devices (UPnP or similar)
- start the client on phone before you want to connect

OK, so I think the problem is UPnP of my PC. It is a company PC where the UPnP setting is set by a policy, which I can not change.

[FJ]

In the next version you will be able to enter the IP to your phone manually