FJ Software

FJ hat geschrieben:since i have no testdevice i have no further info about the bugs.

Please install v1.7. The current beta is made for v1.7

Cheers that did the trick...

In the latest Beta the phone showing isn't the C902 and doesn't show the following, but does the temperature:

Signal
Model
Firmware
IMEI

Still getting the problem with disconnecting too...

In the latest beta we are still having the problem of an error saying sending message failed even though the message has been sent.

kirkie hat geschrieben:In the latest Beta the phone showing isn't the C902 and doesn't show the following, but does the temperature:

Signal
Model
Firmware
IMEI

Still getting the problem with disconnecting too...

I have just restarted MPE a few times and it is all showing now. How strange. But still getting disconnected and always when sending a message...

Still can't send messages either

not quite can't send messages .... I get "send failed" but the message is
sent.

you don't have to write the sam in 2 topics

MPE says send failed or the phone? When you send a SMS through MPE it's normal, that your phone will say "not yet send".

If he has the same problem as me, then MPE states that sending the message failed, however each time the message has in fact been successfully sent by the phone, so its simply MPE reporting it incorrectly.
This only happens with wired connections - bluetooth connections to MPE don't exhibit this problem.

Do we have any update re a fix for the C902 and MPE please?

How should i fix a bug inside the phone ?
If i find a solution or workaround then you will read it here.