FJ Software

Hi..
I have MPE set up via bluetooth and I use the audiogaetway connection to be able to use the pc as headset.. everything works really fine except that when i receive a call I only get one ring in the software and the the software answer the call.. is there any setting i the MPE software that can remove the autoanswer?

MyPhoneExplorer doesn't answer automatically. There is a setting in the phone to auto-answer calls if a hands-free is connected.

Yes I know and that setting is not enabled.
So it is the software that answers.... It's a K800i I have and I've checked all settings that could have autoanswer and disabled them and still MPE allows one ring and then it answers? Can it be that I have missed some settings i the phone?

There are some diffrent places for the same setting in the phone. Check it in your profile and in the Bluetooth-settings.

Hi.
I did a complete factory restore on the phone, But the application stills answer.
I have the phone set up as an audio gateway though can that have something to do with it.

MYPHONEEXPLORER NEVER ANSWER CALLS AUTOMATCALLY.
If you don't believe it you can take a look at the logfile.

This is what the log says when someone rings... can you see what the problem is?

16:01:40.47 [RX]: +CSQ: 99,99
16:01:40.49 [RX]: OK
16:01:46.02 [RX]: RING
16:01:46.03 [RX]: *ECAV: 1,6,1,,,"087750398",129
16:01:46.64 Downloader: RC=6 BytesMax=73 BytesTMP=73 URL=zensiert
16:01:47.72 [RX]: *ECAV: 1,3,1
16:01:50.49 [TX]: AT+CBC
16:01:50.52 [RX]: AT+CBC

The Bluetooth software alone answer a call automatically. If I remember correctly, call will be answered even if You don't use MPE in that moment.

Aahhh.. is there any way to configure this not to answer automatically?

There are some diffrent places for the same setting in the phone. Check it in your profile and in the Bluetooth-settings.

The above log contains no answercommand (it would be "[TX]: ATA")

Anonymous hat geschrieben:Aahhh.. is there any way to configure this not to answer automatically?

If the Bluetooth software you are using don't have an option to configure it, then there is no way of doing that.

I don't know if any of the BT software available have that kind of option.