support for SE Z300i

[samuelcz]

Woul it be possible to add support for SE Z300i phone? Thanks.

[FJ]

I think the Z300 is compatible with MyPhoneExplorer

[samuelcz]

I think the Z300 is compatible with MyPhoneExplorer

I tested it with USB Cable DCU-11 - it works with T630 but it will not recognize Z300i. Is there a possiblility that the connection is blocked by T-Mobile software installed in my phone?
Thanks

[FJ]

No, the connection is not blocked from T-Mobile. Possible that you have a worst contact with your cable. Please also read the english FAQ

[samuelcz]

No, the connection is not blocked from T-Mobile. Possible that you have a worst contact with your cable. Please also read the english FAQ

Thank you, but I am still unable to establish a connection. It recognize DCU-11 cable on port COM 5 and my settings that works with T630 is: baudrate = 115200 and OBEX packetsize = 4096. Shoud I change it for Z300?

[FJ]

I don't know - try the "search-device" Feature of MyPhoneExplorer

[nils]

same problem with my z300i the software can't find my phone

[nils]

hmm no suggestions ? It's to bad that no one have a solution

regards

[FJ]

Read the FAQ. MyPhoneExplorer works with the Z300i - there must be a problem with your connection.

[Gast]

so i read the faq again everything is fine. But i cant connect to my phone, its very possible that the conenction doenst work because i use a driver für usb to com from a different cabel. So i've decied to use this for my SE datacabel

The reason why i use this driver:
I use a seconed party SE datacabel non orginal but (whithout special drivers)i think there is no orginal cabel available. After all my thought it's expensive.


So is it possible to use another driver to emulate a comport?

Best regards

nils

[carkitter]

Z300i is not compatible with DCU-11 cable.

See for yourself on SonyEricsson dot com

[FJ]

Very thanks for this information