FJ Software

I noticed that MPE does not read the timestamp on my w810 right. The clocks are synced and time zones on both the phone and on PC is set to GMT6:00. More info on this: The phone is set to GMT6:00 and the computer is set to GMT6:00 Saskatchewan. Auto Time Zone Update is turned off, and Daylight Savings is turned off.

The thing that is really strange is that when I receive SMS, the Timestamp in MPE reads is always 1 hour ahead of what it actually says on the phone. Thus, if you opened the inbox in the phone it would read the SMS was received at 10:00PM but on MPE it would be shown as 23:00.

Thus, if I received a SMS at 11:00PM, it actually shows up as "Tomorrow, 00:00" in MPE.

Any ideas?

Just a quick note, if I sent a SMS to myself. The sent time would show as 10:00PM and the time shown as received in the Inbox is shown as 10:00PM as well but the time shown in MPE is 23:00.

In which timezone you are living ? Please post also the PDU of the jmessage (rightclick-Properties->>-PDU)

I live in GMT6:00 Saskatchewan
This message also shows as 7:34PM on my actual phone and 20:34 in MPE.

The message was sent on 20:34 GMT-1 . MPE alsways displays the value which was sent with the service-center without GMT-Correction. If i would calculate the GMT-Value for Saskatchewan then the time would be displayed as 15:34 - so whats better ?

This happens only with SMS which were sent from a country outside your timezone so i think its better to keep it as it is now.