FJ Software

Does this software support the W910i? Currently mine says that it can not identify the phone, but i want to know if it should?

Also, it might be an idea to put a sticky thread with a list of supported models.

thanks,
Stubbsy

my mistake, i had to select the right port!

Hi, i cant connect using my w910i...
I dont have a blutooth device on my noteboom, i tried using the cable to connect but
it tells me to remove my battery from my phone for 2 minutes. & it seems my notebook only has 1 com port which is the modem.
Is there any way to connect my phone?

Windows has lots of virtual com ports, don't worry about that. Only com1 & 2 are physical.
just keep the sequence of installation: 1-pc suite, 2-connect the phone, 3-setup the MPE

You have to initiate the BT-Service the first time in your Bluetooth-Software. Please read the FAQ

@Khosrow:
If you are using Bluetooth and a "normal" (non-Symbian) phone then you need no special drivers and also no PC-Suite. Guest1 told:

tells me to remove my battery from my phone for 2 minutes

. This string appears only in the window "SEarch phone" - so MPE did already check all COM-Ports. But anyway thanks for your good engagement in my forum.

Dear Franz,
I'm learning alot from your forum. And really appreciate your attitude.

I upgraded from v1.6.6 to v1.7.1, but when i checked my SMS, if the sender's phonebook entry is not complete with the MSISDN formate, it will not give the phonebook entry name, but the number only. This was not the case with the earlier version. In my case, it would entail editing my whole phonebook.

What is MSISDN formate ?